← All ideas23 Oct 2021hani1OpenGeometry NodesModelinghani1DangryDarknoodlesJhonR3dManBlenderShimoonTopeichUSB10bestelixdsexgussisaurio1ingramjim.conradjozehickskromarmindinsomniamipetr127mitch9sege3wilBrxixi92
Both for the modifier stack list and for the geometry nodes, would be nice.
1
r
richard
Already there: Make manifold in 3D print tools. Also in Mesh -Cleanup menu: fill holes,
m
mindinsomnia
OP is asking for a modifier to do that.
1
r
richard
Always helps to read the question before answering. :-)
Because I do a lot of 3D printing, I regard holes in a mesh as a fault to be eliminated and therefore did not see the need for modifier. In what circumstances would such a modifier be useful?
T
Topeich
If you want to keep the operation alive, non destructive.
r
richard
Yes, of course, but I was asking out of interest why anyone would want or need that. Maybe I'm being obtuse.
7 Comments
this is possible in 3ds Max youtu.be/0hw_fhjUySE
Both for the modifier stack list and for the geometry nodes, would be nice.
Already there: Make manifold in 3D print tools. Also in Mesh -Cleanup menu: fill holes,
OP is asking for a modifier to do that.
Always helps to read the question before answering. :-) Because I do a lot of 3D printing, I regard holes in a mesh as a fault to be eliminated and therefore did not see the need for modifier. In what circumstances would such a modifier be useful?
If you want to keep the operation alive, non destructive.
Yes, of course, but I was asking out of interest why anyone would want or need that. Maybe I'm being obtuse.