fine control over box selection tool tolerance
in blender when i am selecting a mesh with edge selection ive found that an edge is only selected if my marquee passes over the half way point of the edge (although i actually dont think this is always consistent) by default this is a good option but sometimes a user may want to switch the selection mode to either select any edge in the select box at all even when the marquee tool does not pass over the edge midway point, or the opposite where a user may only want to select an edge when it is fully contained within the marquee selection. i propose that there is a toggle similar to what we have for the selection mode toggle but this toggle would be for selection tolerance instead.
1 Comment
Looks like the selection logic is that when there are no full-length edges inside the box to be selected, all the edges that touches the box are selected. If there are full-length edges to be selected, then only those are selected. When using shift, the edges that are already selected aren't counted in this "logic".