Geonodes: Make "Delete Only Edges and Faces" behaviour consistent with Edit mode.

[EDIT] This problem occurs because selections in one domain don't transfer well on another. When brute forcing through edge indices to ensure I have the correct edges selected, the behaviour is as expected.

Original post continues below.

In these first two images we see the behaviour of deleting edges, in edge mode, selecting the option to delete "Only Edges & Faces"

In these next two images, we see the result of issuing an identical command in Geometry Nodes. Using the identical selection, with the command Delete Deometry, selcting the Edge Domain and selecting to delete Only Edges and Faces components of the mesh.

Note that the result is entirely Different.

Changing domains also does not allow for the behaviour to match.

For this specific case, I would argue that while using Delete Geometry using Edge Domain and selecting Only Edges and Faces to delete, that the result should be identical to selecting the same option in Edit Mode using Edge Selection. Below is a mockup of the desired result using the ssame Geometry Nodes setup