Square corner inset option
One issue I found with inset is that since the inset creates trapezoids, loop cuts after an inset are wider on one side. My proposal is to add an option to add square corners instead of doing diagonals. So the inset would look like this:
Which makes loop cuts after nice and even
2 Comments
The idea is good, but not possible; this method would require two additional vertices on each inset edge. Creating them automatically would turn every nearby face into an ngon or perforate the mesh with loop cuts.
* @laurin.graesner * Personally that's a tradeoff I consider completely reasonable. I don't mind that it creates ngons as I can resolve those manually after. but the The amount of work I need to do to straighten the loop cuts due to the angle caused by the trapezoid shape is significantly higher than the work needed to solve the ngon issue at most that's a few quick joins to the opposite corners.
Though now that I've discussed it, while I think this is still a good idea, I think a "Perpindicular" option to loop cuts would also solve my particular issue I'll probably make that an idea as well haha.